Unfortunately, we ran into some snags with our mold removal process. The foam-release agent didn’t work, so the mold bonded to the concrete and it took three days to get it off… At least we didn’t have a male mold!
End of Mold Removal Day 1
Begin Day 2
Yes, we’re digging around under the canoe here
#rollingaroundinfoamonthefloor
Day Three
Ready for the big move to elevate the canoe on the stands
We need to make a cross-section of our canoe showing the three layers of concrete and two layers of reinforcement for our canoe display, so we did a mini-pour-day. The one section took only about 90 minutes and just a few people; much more efficiently than pouring the actual canoe.
Meanwhile, the canoe’s almost ready to de-mold…
Placing Concrete
A low angle of the full canoe
Another creative canoe angle
Working on the second layer of the section
Dry concrete elements await mixing
We filled a few cylinders to strength-test our mix one last time
Packing cylinders. We ended up with a sizable amount of extra mix.
In order to work within our limited budget, we need to get creative with our materials. So instead of throwing out all of our scraps, we reuse them. This year, our bulkhead molds were built out of the cardboard boxes that our reinforcement shipped in. Our cross-section will be made with a section of last year’s canoe mold. We even re-used bulkhead trimmings to re-fill the holes that we popped in our air pockets in those bulkheads. By recycling our materials, we can maximize our small budget to efficiently build our canoe.
Our canoe’s concrete mix is designed to be less dense than water, in order to ensure that it will float (although other factors also influence whether our canoe floats). This year’s mix is less dense than water, but only just. So as an added precaution, we add foam and air pockets (encased in concrete) to the canoe in the bulkheads (at the bow and stern). This way we have some added flotation factor just in case something goes wrong with our mix design!
The environmental design team is creating a municipal sewer system. (See full competition guidelines here). Tonight, they made some replica sewage and tested out the mock-up of their design. Unfortunately, we can’t post pictures of the design, but here are some of the team making test sewage:
The male mold is protecting the female mold, which has our baby in it.
~ Erin Khan, Concrete Canoe Co-Captain, summarizing our tactic of using the spare foam pieces that were cut out of the mold (the male mold) to shelter/hide the female mold, which has the canoe we just poured in it, from passers-by while it cures.
American Society of Civil Engineers Student Chapter at the University of Southern California